Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Repair in Prospect Heights, NY
Chimney repair in Prospect Heights usually starts with spalling brick, a loose crown, or a draft that shows up when the heat comes on. In these 1880s – 1910s brownstones those symptoms tend to trace back to the same causes: cracked clay flue tiles after a century of settling, mortar that’s given way through decades of freeze-thaw, and flues that are shared with the rowhouse next door. We work on exactly this kind of chimney, in exactly this kind of building. Call (855) 724-0919 for a free estimate.

Getting the diagnosis right matters more here than in most places. A chimney that looks intact from the roof can still have a flue that was sealed off decades ago, or a liner that’s shifted just enough to let one flue vent into its neighbor. We work from camera evidence, not from what the outside suggests.
Why Prospect Heights Homeowners Call Us for Chimney Repair
Prospect Heights is full of buildings where the chimney was never designed to be serviced from the outside alone. Flues sit inside shared party walls. Exterior signs of a problem are often missing. That changes how repair work has to be planned, and it’s the part most sweep-only outfits don’t account for.
We treat the chimney as one system: liner, crown, flashing, masonry, cap. If the flue needs resurfacing, we use HeatShield, the ceramic restoration system that rebuilds the liner’s interior surface without a full reline. If the crown is cracked or the flashing has pulled away from the brick, that gets handled by the same specialist who did the inspection. You’re not juggling three contractors for one chimney.
Our technicians have up to 11 years of experience with brownstone chimneys, party-wall flues, and the kind of older masonry you find throughout this neighborhood. If any exterior alteration is needed, we know the Landmarks Preservation Commission rules apply and factor that into planning before we touch the brick.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Repair Services in Prospect Heights
Mortar Repointing
Repointing is the most common repair on Prospect Heights chimneys. The mortar between original brick joints erodes faster here than the brick itself, partly because the East River humidity keeps the masonry damp longer, and partly because the heating season runs hard and then stops. We grind out the failed joints and repack them with mortar matched to the original brick’s hardness. Soft modern mortar against old hard brick can crack the brick face, so the mix matters as much as the technique.
Spalling Brick Repair
Spalling is what happens when water gets into the brick and freezes. The face pops off. On Prospect Heights rowhouses that show original brick chimneys above the roofline, spalling tends to cluster around the crown and the top few courses where freeze-thaw hits hardest. We replace the damaged units and address whatever is letting water in, rather than just patching the surface.
Chimney Waterproofing
Waterproofing is the repair that prevents the next repair. We apply a breathable treatment to the masonry that keeps rain out but lets moisture escape from inside. Sealing a chimney with a non-breathable product traps water and makes spalling worse, which is why the product choice matters. On a Prospect Heights brownstone, this is usually paired with crown repair and flashing work so the whole top of the chimney is protected as a unit.
Flashing Repair
Flashing is the metal where the chimney meets the roof. When it fails, water runs down inside the chimney chase and shows up as staining on interior plaster, not on the roof. In these rowhouses the flashing detail sits close to a shared wall, so a repair often needs coordination with the adjacent owner before anyone gets on the roof. We inspect the flashing alongside the crown, because the two fail together more often than not.
Trusted Brands We Use in Prospect Heights
We supply and install only professional-grade chimney components from brands like HeatShield, Gelco, Olympia Chimney, Famco, and Copperfield. These are the same materials certified chimney specialists use nationwide, not hardware-store substitutes. HeatShield handles ceramic liner restoration when the flue is sound but the surface is compromised. Gelco and Olympia Chimney supply the crowns, caps, and liner components that go into a repair. Famco covers the masonry and structural side. Because we work with these suppliers directly rather than stocking our own inventory, we can source the right part for your chimney and get it on site without delay.
Common Chimney Repair Problems We See in Prospect Heights Homes
- Shared flue cross-contamination. In a party-wall chimney, sweeping one side can push soot or debris into the adjacent rowhouse’s flue. We check the shared stack with a camera before any sweeping so the neighbor’s flue doesn’t get fouled.
- Hidden flue seals. A flue that was capped off decades ago leaves no mark on the outside of the building. Without a camera inspection, a repair on a neighboring flue can block ventilation for a sealed one, or miss a liner that needs replacing.
- Freeze-thaw spalling. Cold winters followed by the damp that comes off the East River accelerate mortar decay on original brick. When the mortar goes, water gets into the brick face, and the crown and flashing start to fail with it.
- Cracked or shifted clay tiles. Original clay liners in these brownstones were never meant to last a hundred years. Settling shifts the tiles, the joints open, and the flue stops being gas-tight. This is what a Level 2 inspection is designed to catch.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Repair in Prospect Heights, NY
Chimney repair in Prospect Heights typically runs from a few hundred dollars for targeted repointing to several thousand for a full chimney rebuild. The estimates below are a starting range for this market; the written estimate sets the final price.

| Repair | Estimated Range |
|---|---|
| Mortar repointing (limited area) | $350 – $900 |
| Spalling brick replacement | $500 – $1,500 |
| Chimney waterproofing | $300 – $700 |
| Crown repair or rebuild | $600 – $1,800 |
| Flashing repair | $400 – $1,200 |
| Full chimney rebuild | $4,000 – $12,000 |
Cost depends on height, access, how many courses of brick need replacing, and whether the repair involves a shared flue that requires coordinating with the adjacent owner. A chimney on an internal party wall takes more planning than one on an open roofline. The estimate is free, and we tell you what can wait versus what shouldn’t.
Why Prospect Heights Chimneys Fail Differently
Most of the chimneys in this neighborhood sit inside shared party walls, which means a flue serving one rowhouse can vent into the flue next door if the liner joints have opened. You can’t see that from the roof. The exterior can look perfectly sound while two flues are cross-contaminated behind the brick. That’s why a camera inspection comes first, before any sweeping or repair, on a shared stack: we need to know what’s connected to what before we change anything.
A repair here also has to respect Landmarks Preservation Commission rules whenever exterior work is involved. That’s a layer of planning you won’t run into in a newer building, and it’s why we factor approval timing into the estimate rather than discovering it mid-job.
A typical job in Prospect Heights often starts when a homeowner notices spalling brick above the roofline or a draft during the heating season. The technician finds the flue liner cracked or shifted after decades of settling, sometimes affecting the flue shared with the neighboring rowhouse. The fix usually involves right-of-entry coordination with adjacent owners, a Level 2 camera inspection to check for sealed-off flues, and then repointing or brick repair to restore the chimney’s integrity. Exterior changes get planned around LPC requirements.
We Also Serve Nearby Neighborhoods
The same conditions apply across this part of Brooklyn. We serve Prospect Heights and work in Clinton Hill, Fort Greene, Williamsburg, and Crown Heights, where party-wall chimneys and older rowhouse masonry are the norm. If you’re in one of these neighborhoods and dealing with a chimney that’s spalling, leaking, or pulling a draft, call and we’ll book an inspection. Call (855) 724-0919. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Serving Prospect Heights, NY – Our Local Coverage Area
We serve Prospect Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Repair in Prospect Heights
You can’t tell from the outside; only a camera inspection inside the flue can confirm it. Shared party-wall chimneys are common in Prospect Heights brownstones, and the connection isn’t visible from the roof or the parlor floor. We run a Level 2 camera inspection before any sweeping or repair on a shared stack so we know exactly what’s connected. Call (855) 724-0919 for a free estimate.
Any exterior alteration to a chimney on a landmarked Prospect Heights building generally requires Landmarks Preservation Commission review before work begins. Interior flue work usually doesn’t trigger it, but crown, brick, or flashing changes on the visible roofline do. We build that approval timeline into the plan so the repair isn’t stalled mid-job. Call (855) 724-0919 to discuss your building.
The combination of cold winters and humid air off the East River keeps original brick and mortar damp longer here, which accelerates freeze-thaw damage. Brownstone chimneys from the 1880s – 1910s have had a century of it. We repair the spalled units and address the water intrusion behind them, rather than patching the face. Call (855) 724-0919 for a free estimate.
Yes, and it happens often. A flue can be capped or blocked decades ago with no mark left on the outside of the building. That’s why a camera inspection is essential before any repair on an adjacent flue: skipping it can block ventilation for a sealed flue or miss a liner that needs replacing. Call (855) 724-0919 to book an inspection.
Glazed, third-degree creosote is common in Prospect Heights because the long idle summer lets creosote harden on the flue walls after heavy heating-season use. It can’t be swept off with a brush alone and usually calls for rotary cleaning or chemical treatment. We assess the creosote level as part of the inspection. Call (855) 724-0919 for a free estimate.
If your chimney is showing spalling brick, a draft, or a crown that’s started to crack, the next step is a camera inspection and a written estimate. Call (855) 724-0919. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Bedford-Stuyvesant.